site map | search

HVAC Silicon Nitride Hot Surface Igniters
Silicon Nitride BenefitsFrequently Asked QuestionsWhere to BuyUniversal Igniters400 Series Igniters600 Series IgnitersSmart-lite Igniter
Igniters Direct - Glo-406 Silicon Nitride Hot Surface Igniter Technical Data
technical data
fitting instructions
types replaced
Glo-401 Silicon Nitride Hot Surface Igniter
Glo-406 part no. HSIURK120V406
Silicon Nitride heating element
Heater cemented into ceramic insulator using white ceramic cement
Ceramic insulator body glazed 95% alumina - glazed finish
Cable - PTFE - U/L Specification - temperature rating 250°C
Specification
Time to 1200¼C
> 12 seconds @ 120 volt
Current
3.3-4.2 amps
Operating Voltage
120 volts +10% -15%
Power Rating
400-500 watts

Note. This unit cannot be used as a flame sensor.
 
© 2008 direct brand limited | trademarks - ignitersdirect™ silicon nitride hot surface igniters | terms
Direct Brand Limited, 11b Depot Street, South Grafton MA 01560, T 508-839-0013, F 508-519-0397 is a member of HARDI