Fitting
Instructions for type 3 assembly (above)
Please
read all these instructions to the end carefully before
beginning installation.
1.
Identify which type of hot surface igniter is inside
your appliance (see igniter
types table).
2.
Unplug your existing igniter, retaining all fittings,
and match it up with diagrams above (this can also be
done by comparing the top end view of the base type).
3.
Compare the position of the ridge on your existing igniter
carefully to the top view diagram. Ensure that you have
the correct igniter type. Take your time to identify
this carefully.
4. Referring to the centre bottom diagram, break off
the tabs A and B, preferably with thin nose pliers.
5.
Cut off the plug from your appliance, as close to the
plug as possible. Make sure there is enough lead to
work with. Bare one quarter of an inch of wire.
6.
Fit the universal adaptor to the appliance using existing
screws. Once the universal adaptor is fitted, screw
the igniter into the adaptor, as per the final diagram,
using the screw provided.
7.
Attach the wires from the appliance onto the igniter,
by twisting the bared ends together, matching one wire
from the igniter, to one wire from the controller (please
refer to diagram).
8.
Finally, take the terminal caps provided and screw down
tight over the joined bare wires, ensuring that no bare
wires are showing. If necessary, the igniter wires can
be cut to length.
9.Check
installation is secure and safe, routing leads away
from the burner.
Commissioning
1. Turn on the gas supply and electrical supply to the
appliance.
2.
Set the room thermostat for heat.
3.
Test furnace for proper ignition and operation.
4.
Verify that the Power-On LED, on the power module, is
on during the Glo-Stix ™ igniter warm-up.
5.
During igniter warm-up, using a true RMS voltmeter,
measure the voltage across the igniter. Voltage should
be between 50 VAC and 120 VAC.
6.
Make sure the Glo-Stix ™ igniter does not remain
energized in the flame for more than a few seconds.
7.
Replace the burner compartment door.
8.
Place Glo-Stix ™ upgrade label on front of the appliance,
write the date of installation and your contact details.
Note. This unit cannot be used as a flame sensor.
|
