Over
time many part numbers for igniters have been generated, most
refer to the same igniter, but with the modification of extra
lead lengths and so on. All igniters fit into a burner housing
that has only a few variations. Therefore the universal bracket
kit can be used in a simple series of combinations to replace
over 100 types of the most commonly used hot surface igniter.
The most common combination requires you to remove tab B and
C and is applicable to a large range of igniter types.
First
you will need to identify the igniter installed in the appliance.
The igniter replacement table
will then guide you to one of six bracket combinations (the
six assembly diagrams are also provided in the left hand column).
Each assembly diagram page has numbered instructions for you
to follow. All assemblies require you to reuse original screw
fittings. Combination 5 and 6 will require the use of other
parts of the original fixings.
View
with tab A face down.
Note. This unit cannot be used as a flame sensor.
|
.jpg)