Fitting
Instructions
Please
read all these instructions to the end carefully
before beginning installation.
1.
Turn off the gas and electrical supply to the
appliance.
2.
Unplug your existing igniter, retaining all fittings.
3.
Visually check your igniter and cross reference
with fitting diagrams (above) to identify the
correct fitting configuration. Fit bracket and
spacers where required.
4.
Cut off the plug from your appliance, as close
to the plug as possible. Make sure there is enough
lead to work with. Bare one quarter of an inch
of wire.
5.
Fit the igniter to the appliance using screws
provided.
6.
Attach the wires from the appliance onto the igniter,
by twisting the bared ends together, matching
one wire from the igniter, to one wire from the
controller.
7.
Take the wire nuts provided and screw down tight
over the joined bare wires, ensuring that no bare
wires are showing.
8.
Check installation is secure and safe, routing
leads away from the burner.
Commissioning
1. Turn on the gas supply and electrical supply
to the appliance.
2.
Set the room thermostat to maximum if applicable.
3.
Test appliance for proper ignition and operation.
4.
Verify that the Power-On LED, on the power module,
is on during the glo-stix® igniter warm-up.
5.
Make sure the glo-stix® igniter does not remain
ignited for more than a few seconds if applicable.
6.
Refit cover and make tidy.
7.
Place glo-stix® upgrade label on front of
the appliance, write the date of installation
and your contact details.
8.
Turn room thermostat to normal setting if applicable.
|
Fire
Hazard
Shock
Hazard
Explosion
Hazard